山东干燥机常见的清洗办法有哪些？

干燥机正常运转后，应定时查看各体系的运转状况，并记录工艺参数。一 天完毕时，应先封闭加热设备，用水替代液体冲刷物料的剩下液体，然后封闭物料泵。当进口温度降100度以下后，可中止风机和排风机的运转。

After the dryer is in normal operation, check the operation status of each system regularly and record the process parameters. At the end of the day, the heating equipment should be closed first, and then the material pump should be closed. When the inlet temperature drops below 100 ℃, the fan and exhaust fan can be stopped.

然后清洗干燥塔和除尘器，封闭除尘器和空气锤，封闭总电源，完结出产操作，紧迫状况下，设备有必要当即封闭，鼓风机和物料泵应首要封闭。假如遇到电源毛病，应自然然冷却，然后翻开排污阀，排空泥浆管道，清洗设备。

Then clean the drying tower and dust remover, close the dust remover and air hammer, close the main power supply, and complete the production operation. Under the urgent situation, it is necessary to close the equipment immediately, and the blower and material pump should be closed first. In case of power failure, it should be cooled naturally, then turn on the drain valve, drain the mud pipeline, and clean the equipment.

别的，运用完毕后，应将喷淋盘取出，浸入水中，清洗剩下水。洗不洁净的时候用刷子擦拭。由于喷雾盘上的残留物会形成喷雾不平衡，严重影响喷头的运用寿命，乃损坏其他机件。因而,应，该有一个固定的结构。注意：为了保证干燥塔体及其管道及与制品接触的部件都要清洁。

In addition, after using, the spray tray should be taken out, immersed in water, and the remaining water should be cleaned. Wipe with a brush when it is not clean. Because the residue on the spray tray will cause spray imbalance, it will seriously affect the service life of the sprinkler and even damage other parts. Therefore, there should be a fixed structure. Attention: in order to ensure that the drying tower body and its pipes and parts contacting with products are clean.